1. Fix the Extended Arm onto the Base with Cap & M6 screw as shown in Fig. 1.
2. Tighten the grub screw shown in Fig. 1a.
3. Drill Ø 10.5mm hole through out on table top on the desired position & Mount the Base as shown in Fig. 2.
4. Fix the Diagonal arm onto Extended Arm with Cap & M6 screw & then Tighten the grub screw as shown in Fig. 3.
5. Screw the Flat Screen to the Mounting plate as shown in Fig. 4.
6. Pressure can be adjusted by tightening and loosening the screw as shown in Fig 5.
7. Thighten the screw to adjust the load of the monitor as shown in Fig.6.