Bottom Mounting Drawer Slides

1. Side gap of 12.7 mm (1/2") per side required (Refer fig. 1).
2. 25.4 mm (1") clearance from top edge of drawer required to tilt and remove drawer (Refer fig. 2).
3. Fixed and moving slide should be equally offset by 2 mm for Auto-Closing (Refer fig. 2).
4. Recess screw heads to avoid interference.
5. A set of slides must be fitted parallel and at same heights to each other.

For efficiency and durability.

• Side gap of 12.7 mm (1/ 2") per side is most important.
• Fix slides parallel and at equal height.
• Do not apply paint or polish.